LC-EM-1320

From LCWIKI
Jump to: navigation, search

Product Name

LC CH348Q USB to 8-channel TTL serial port module, multi-channel serial port expansion module, USB to 8-channel UART with built-in LED indicator light, onboard 0.5A fuse overcurrent protection, PH2.0 horizontal patch terminal


About

The LC USB to eight TTL serial port module is developed based on the CH348Q chip, which can convert one USB interface into eight UART serial ports.
It has Type-C 5V DC input, built-in LED indicator light, input terminal board with 500mA fuse, supports overcurrent protection, adopts PH2.0 horizontal patch terminals,
and has the characteristics of overcurrent protection, high performance, low power consumption, and low cost.


View

Front view

LC-EM-1320-01.png

Side view

LC-EM-1320-02.png

Reverse image

LC-EM-1320-03.png


Introduction and Explanation

Size: 45 * 91mm/20 g

LC-EM-1320-04.png

Interface Introduction:

LC-EM-1320-07.png

① USB port
② 500mA fuse
③ Serial port
④ Power indicator light
⑤ Chip: CH348Q
⑥ Serial port indicator light

Technical parameters:

1. Chip model: CH348Q

2. Input voltage: 5V DC

3. Input interface type: USB Type-C

4. Output type: Eight TTL UART serial ports

5. Output terminal specification: PH2.0 horizontal patch terminal

6. Overcurrent protection: Onboard 500mA fuse

7. Indicator lights: power indicator light and eight UART signal indicator light


Functional Features

  • Supports USB to eight UART conversion
  • The output terminal adopts PH2.0 horizontal patch terminal
  • Comes with power indicator light and eight UART signal indicator lights
  • Input end board with 500mA fuse, supporting overcurrent protection


Module usage instructions

1. Install USB drivers on the computer

Official driver download website

2. Connect the input end to the computer USB port, and connect the TX and RX of the output end with jumper caps.
At this time, the LED power indicator light will light up

LC-EM-1320-06.png

3. At this point, open the USB device viewer or the built-in device manager on the computer,
which will display information about the USB device and four COM ports

LC-EM-1319-07.png

LC-EM-1319-08.png

4. Open the serial debugger, select one of the serial port numbers, choose the appropriate baud rate, open the serial port and send data.
The window will receive this data without packet loss, as shown in the following figure:

LC-EM-1319-09.png



User Manual Download

For more product information, please refer toBaidu Netdisk Extraction code: fkum